Day 5 - Photos (ALL)

-











Comments

Post a Comment

Popular posts from this blog

Day 7 - Sayer

-
Now the last blog implied that the project was done, but it wasn't, the primary assembly was done. Day 7 was relegated primarily to tidying it up and applying edge banding. Which is a lot harder than you'd think. You have to press down a thin veneer with a hot iron and if you screw it up by any more than 1/16" you gotta do it again loser. I used probably double the material I needed to due to stupid mistakes, but it doesn't matter, I got it done eventually.      Once the edge banding was finished, I needed to do one of the final steps, sanding the whole thing down. This was probably the most stressful step and a lot of the edge banding was screwed up by my imprecision or tendency towards mistakes in general. However, that step was finished with the shelf intact and thank god for it because that was stressful. I was sorta left to myself for a good while until it was finally time to attach the backing. Now the backing was cut from this massive floppy 1/8" plywood bo...
Read more

Day 5 - Sayer

-
 Today was another rather nice experience because we got a [REDACTED]load of stuff done on the shelf, with enough break time in between to not have it get grating like Thursday was. We started the day out with dado-ing the remaining few that needed to get done. After that was done I tried to fit everything together, and it didn't work on one end. So we removed some of the veneer and tried again, it didn't work, so we removed even more of the veneer, and it worked. It worked so well that it almost got stuck. Which would've been pretty bad. Now, all we have to do for the main shelf body is remove some of the wood from the back to make the backing fit better, actually cut out the backing itself, and stick it all together. After that we need to cut out the felt, place it on the spots, make it look nice, apply the edge banding, and make the holders. The holders will be pretty cool, and will also probably have some form of a design laser cut onto the sides of them. Oh right the o...
Read more

Day 8 - Sayer

-
 The final day of the program was a tough one almost exclusively due to the final hour, which involved me actually getting my shelf home through the pouring rain. Most of the day itself focused specifically on the finalization of my shelf, mostly in regards to sanding and adding on the last pieces. Those aforementioned last pieces were the holders and the felt pads. The holders were what the day seemed to primarily focus on. The first half of the day was spent mostly with me sanding down the top and edges of my shelf while the CNC router cut out my holders. After lunch I came back and passed the results through the planer, ending up with two equally sized really good looking holders that I placed aside so I could finish the sanding. After the sanding was done however I added them to the top and had Mr. Grisbee teach me how to properly screw them in. After they were properly screwed in I sat back for a moment before beginning to work on the felt. Now the felt wasn't the issue, it wa...
Read more