Day 2 - Photos (ALL)

-

Our collection of wood #veryheavy

Sutton balances precious cargo #flamingostance


Secret Catherine sighting! #ignorecautiontape

w/the cool Home Depot cart #hardwork

Sayer and Sutton carefully maneuver the cart down the aisle #theyseeusrollin


 Testing the strength of a stack of plywood #itwasprettystrong

#girlswhowoodwork


New friend! #rockler


Sayer and Sutton balance a rather bendy piece of wood #teamworkmakesthedreamwork 











Comments

  1. Darlynn WareMarch 23, 2021 at 5:36 PM

    Really nice looking wood. This is going to be fun watching you all turn that lumber into your projects

    ReplyDelete

Post a Comment

Popular posts from this blog

Day 8 - Sayer

-
 The final day of the program was a tough one almost exclusively due to the final hour, which involved me actually getting my shelf home through the pouring rain. Most of the day itself focused specifically on the finalization of my shelf, mostly in regards to sanding and adding on the last pieces. Those aforementioned last pieces were the holders and the felt pads. The holders were what the day seemed to primarily focus on. The first half of the day was spent mostly with me sanding down the top and edges of my shelf while the CNC router cut out my holders. After lunch I came back and passed the results through the planer, ending up with two equally sized really good looking holders that I placed aside so I could finish the sanding. After the sanding was done however I added them to the top and had Mr. Grisbee teach me how to properly screw them in. After they were properly screwed in I sat back for a moment before beginning to work on the felt. Now the felt wasn't the issue, it wa...
Read more

Day 8 - Catherine

-
Image
Today was the last day of the Advanced Woodworking A-term and for us seniors the last day of Post Oak J/A Terms as a whole... On another note, I finally finished my cutting board! I had to veer a little from the original design but all in all, I am very happy with the final product and learned a lot in the process. I started the day by gluing the handle back onto the cutting board with the longer clamps at school. This glue-up called for an additional extremely long waiting period for the glue to dry. Since I couldn’t finish my project just then I spent the morning roaming around the Tinkeria, watching Sutton try to saw off the excess wood from her project, and even started making the A-Term Presentation slides in an attempt to make the glue dry faster. By the time we finished our lunch break, my cutting board was dry enough for the next step. Recalling yesterday’s incident, I hesitantly approached the router again. Mr. Grisbee wisely decided to stand on the left side of the router thi...
Read more

Day 3 - Catherine

-
Day 3!! Having gone to Home Depot and Rockler yesterday, we were all set to start the real work today. Mr. Grisbee gave us a lesson on how to use the planer and the jointer, two woodworking machines that help to level out the wood. My first step was to cut the huge 98" long walnut plank and shorter but equally oversized 60" maple plank into manageable pieces. As my cutting board design is 12", I cut the wood into 13" pieces to account for the planing and sanding that will happen at the end. I then used the jointer to sand out the edges. I only ran the walnut through the jointer because the maple was too wide. I found it tricky to use the jointer with the wood placed horizontally because as you push the wood through with the two push grips you are supposed to lift one hand up and place it in front of the other one to evenly guide the wood through but I apparently did not have the coordination for that. I was also supposed to mark arrows on the sides of the wood to ea...
Read more